인문학
사회과학
자연과학
공학
의약학
농수해양학
예술체육학
복합학
DBpia AI
AI 에이전트
AI 아이디어
AI 리더
AI 뷰어
Citeasy
크롬 서지관리 다운로드
지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술저널
- 저자정보
- 발행연도
- 2025.12
- 수록면
- 637 - 644 (8page)
이용수
초록· 키워드
The Sn-3.0Ag-0.5Cu (SAC305) solder, widely used in the electronics industry, exhibits excellent wettability and mechanical stability. However, its relatively high melting point of 217 °C can cause thermal damage and interfacial delamination during repeated reflow processes. As an alternative, the Sn-58Bi solder, with a low melting point of 139 °C, has attracted significant attention. Sn58Bi solder is cost-effective and shows favorable mechanical proper- ties and wettability. Nevertheless, its high Bi content (58 wt%) leads to brittleness and the formation of coarse Bi-rich phases, which degrade joint reliability. To overcome these limitations, a hybrid solder structure combining Sn58Bi and SAC305 has been proposed, allowing the integration of the low processing temperature of Sn58Bi with the mechanical robustness of SAC305. However, conventional reflow soldering still involves a high thermal load and long processing time, which result in excessive energy consumption and accelerate intermetallic compound (IMC) growth and warpage. To address these issues, this study adopts intense pulsed light (IPL) soldering, which utilizes the photothermal effect of a Xe flash lamp as an alternative process. The IPL process enables localized heat- ing within a few seconds to induce solder melting and bonding, allowing the formation of a thin IMC layer with precise temperature control. In this study, Sn58Bi solder paste was printed on Cu pads, and SAC305 solder balls were mounted on top to form a hybrid joint structure. The joints were then fabricated using both reflow and IPL soldering processes, and their microstructural and mechanical properties were compared according to the process conditions. As a result, the IPL process produced a thinner IMC layer than reflow soldering and, although it exhibited slightly lower shear strength, the increased shear displacement indicated improved ductility of the joints.
상세정보 수정요청해당 페이지 내 제목·저자·목차·페이지정보가 잘못된 경우 알려주세요!
목차
- Abstract
- 1. Introduction
- 2. Experiment Method
- 3. Results and Discussion
- 4. Conclusion
- References
참고문헌
참고문헌 신청최근 본 자료
UCI(KEPA) : I410-151-26-02-094591683
