지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술대회자료
- 저자정보
- 저널정보
- 한국소성·가공학회 기타자료 The 8th International Conference and Workshop on numerical simulation of 3D seet metal forming processes (NUMISHEET 2011)
- 발행연도
- 2011.8
- 수록면
- 717 - 724 (8page)
이용수
초록· 키워드
오류제보하기
Studies based on numerical simulations of axisymmetric parts showed that the scaleability of strain distribution as described above was limited to only about 60% geometric upscaling in conventional forming of a cylindrical part and to about 90% upscaling in hydroforming. These findings may be criticized as they amount to verification of the scaleability of the differential equations being solved.
In this context experiments were performed on cylindrical sheet metal cups drawn to three different diameters keeping the draw ratio as well as the R/t ratio at the die entry and the punch nose constant. The meridional strain distribution was determined using GOM automatic strain measuring system. The strain distribution was fitted into a Fourier series and the variation of the Fourier coefficients with punch travel plotted for the three sizes investigated. This variation in the major Fourier coefficients was found to run parallel indicating scaleability of the strain distribution. An attempt was made to predict the strain distribution in the larger cup based on that in the smallest one.
During the course of the simulation based studies, it was noticed that the sine coefficients show a sudden increase at imminent failure. This was borne out by the measured strain distribution using a uniaxial tensile sample and that from the deep drawn cups that failed during the experimentation.
In this context experiments were performed on cylindrical sheet metal cups drawn to three different diameters keeping the draw ratio as well as the R/t ratio at the die entry and the punch nose constant. The meridional strain distribution was determined using GOM automatic strain measuring system. The strain distribution was fitted into a Fourier series and the variation of the Fourier coefficients with punch travel plotted for the three sizes investigated. This variation in the major Fourier coefficients was found to run parallel indicating scaleability of the strain distribution. An attempt was made to predict the strain distribution in the larger cup based on that in the smallest one.
During the course of the simulation based studies, it was noticed that the sine coefficients show a sudden increase at imminent failure. This was borne out by the measured strain distribution using a uniaxial tensile sample and that from the deep drawn cups that failed during the experimentation.
목차
Abstract
1. INTRODUCTION
2. APPROACH
3. RESULTS AND DISCUSSION
4. CONCLUSIONS
5. REFERENCES
참고문헌 (0)
참고문헌 신청이 논문의 저자 정보
최근 본 자료
댓글(0)
0