지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술대회자료
- 저자정보
- 저널정보
- 한국소성·가공학회 기타자료 The 8th International Conference and Workshop on numerical simulation of 3D seet metal forming processes (NUMISHEET 2011)
- 발행연도
- 2011.8
- 수록면
- 1,129 - 1,136 (8page)
이용수
초록· 키워드
오류제보하기
The effect of bottoming on the reduction of springback was investigated by performing U-shaped bending experiments and corresponding 3D FE simulation on 590㎫ level high strength steel sheet. From experiments using three punch-die sets, each have different gaps between punch and die (0, 5 and 10% less than the sheet thickness) at punch corner, it was clarified that springback decreases with increasing bottoming load to some extent but a certain amount of springback remains even under a higher load. From 3D FE simulation of the bottoming on U-shaped bending, it was found that bending stresses at punch R-corner are much reduced by bottoming, but these stresses around the end of R-corner cannot be eliminated. This is a reason why complete elimination of springback by bottoming on U-bending is so difficult. Therefore, it would be recommended in actual press forming operations to apply a certain amount of bottoming load, but it should not be too large, for reduction of springback. Another important conclusion, found in the present study, is that an appropriate choice of material model is essential for accurate FE simulation of bottoming. Furthermore, deformation of punch/die slightly affects the springback. The best combination is the use of Yoshida-Uemori kinematic hardening law for material model and 3D deformable solid model for tools.
목차
Abstract
INTRODUCTION
EXPERIMENTAL
3D FE SIMULATION OF SPRINGBACK AFTER U-BEND
DISCUSSION ON BOTTOMING EFFECT
CONCLUDING REMARKS
REFERENCES
참고문헌 (0)
참고문헌 신청이 논문의 저자 정보
이 논문과 함께 이용한 논문
최근 본 자료
댓글(0)
0