인문학
사회과학
자연과학
공학
의약학
농수해양학
예술체육학
복합학
DBpia AI
AI 에이전트
AI 아이디어
AI 리더
AI 뷰어
Citeasy
크롬 서지관리 다운로드
지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
초록·키워드
The cutting process of the cantilever tunneling machine mainly generates excitation through the cutting motor or the hydraulic cylinder driven by the hydraulic system. Regardless of the driving method, the frequency width of the excitation system is limited, difficult to control, and the excitation effect is poor. Therefore, in order to improve excavation efficiency, the excitation system parallel to the original cutting and rotating system is designed. Based on the excitation characteristics caused by alternating fluid flow, the core component of the excitation system, hydraulic exciter, is designed, and the dynamics and dynamic characteristics of the excitation system are analyzed. Based on AMESim software, analyze the impact of factors such as pump displacement, excitation frequency, and pipeline parameters on the operational performance of the electro-hydraulic vibration cutting system, and conduct experimental verification by building a cutting test bench. The experimental results show that as the inner diameter of the pipeline increases, the fluctuation at the acceleration turning point decreases in each cycle and approaches the peak faster. As the excitation frequency increases, the cutting acceleration of the electro-hydraulic excitation cutting system decreases first and then increases, verifying the accuracy of the simulation results. In the experiment, it was found that the acceleration transformation range of the cutting head of the excitation system is the smallest and most stable when the excitation frequency is 30 Hz. In order to verify that the excitation frequency of 30 Hz is the optimal frequency, further contact force tests were conducted on the cutting teeth. It was found that when the hydraulic excitation system adds a 30 Hz excitation frequency, the contact force on the cutting teeth is the smallest. It is more conducive to reducing the damage and wear of the cutting head, and the cutting effect of the cutting head is more obvious. The research results are beneficial for improving the cutting performance of the electro-hydraulic excitation cutting system, providing theoretical support for the selection of cutting parameters for excavation machinery and hydraulic excitation, and improving the existing theoretical system for active excitation cutting vibration analysis of excavation machines.
인공지능 문자 인식 모델을 통해 추출된 텍스트로, 일부 오타나 오류가 포함될 수 있으나 지속적으로 개선 중입니다.
오류를 발견하셨다면 해당 부분을 드래그한 후 ' 를 통해 신고해주세요.
오류를 발견하셨다면 해당 부분을 드래그한 후 ' 를 통해 신고해주세요.
최근 본 자료 전체보기
