지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
초록· 키워드
오류제보하기
It has already been known that quenching effect is influenced greatly by stirring and changing coolant's temperature on quenching.
But according to the past investigations its effect has not been taken into consideration quantitatively in the cooling process.
The purpose of this study is that the influence of flow rate and temperature on the quenching effect of cooling water as quenching medium is quantitatively examined by using the open channel.
The stream of water in this study is turbulent flow. The temperature of the specimen made of pure copper is measured by CA thermocouple in the vicinity of the surface and recorded by an automatic recorder during the quenching process in city water.
The results obtained are as follows;
1. The quenching effect of cooling water generally increases with Reynolds Number (characteristic length: specimen diameter) as shown in the experimental formula; H-H_50=1.7 x 10^-8 (Re_D) (Pr)^I.77 D^-I.
But at the realm of Reynolds Number from 1.2 x 10^4 to 9.2 x 10^4, the increasing rate of quenching effect shows little increase.
2. The increasing rate of quenching effect was increased under the flow rate of 221 cm/sec. On the other hand, it was decreased below this flow rate.
3.The quenching effect was influenced by the water temperature and the flow rate. But it was rather dependent upon the former than the latter.
4. Although the quenching effect appeared loosely in the water temperature of 50°C, it was shown that the qunching effect increased in the low flow rate of 31 cm/sec. comparing with the still water.
5. It is desirable to design the quenching system to be over 1.2 x 10^4 in Reynolds Number or over, 3000cm^-1 in V /v in order to increase the quenching effect of the system using open channel.
But according to the past investigations its effect has not been taken into consideration quantitatively in the cooling process.
The purpose of this study is that the influence of flow rate and temperature on the quenching effect of cooling water as quenching medium is quantitatively examined by using the open channel.
The stream of water in this study is turbulent flow. The temperature of the specimen made of pure copper is measured by CA thermocouple in the vicinity of the surface and recorded by an automatic recorder during the quenching process in city water.
The results obtained are as follows;
1. The quenching effect of cooling water generally increases with Reynolds Number (characteristic length: specimen diameter) as shown in the experimental formula; H-H_50=1.7 x 10^-8 (Re_D) (Pr)^I.77 D^-I.
But at the realm of Reynolds Number from 1.2 x 10^4 to 9.2 x 10^4, the increasing rate of quenching effect shows little increase.
2. The increasing rate of quenching effect was increased under the flow rate of 221 cm/sec. On the other hand, it was decreased below this flow rate.
3.The quenching effect was influenced by the water temperature and the flow rate. But it was rather dependent upon the former than the latter.
4. Although the quenching effect appeared loosely in the water temperature of 50°C, it was shown that the qunching effect increased in the low flow rate of 31 cm/sec. comparing with the still water.
5. It is desirable to design the quenching system to be over 1.2 x 10^4 in Reynolds Number or over, 3000cm^-1 in V /v in order to increase the quenching effect of the system using open channel.
목차
Abstract
1.序論
3.實驗
4.實驗結果 및 考察
5.實驗에 대한 綜合的 考察
6.結論
參考文獻
참고문헌 (0)
참고문헌 신청함께 읽어보면 좋을 논문
논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!
-
Flow Effects and Modeling in Gas-Cooled Quenching
Heat Transfer Conference
1998 .08
-
직접Quenching 열간 단조용 비조질강의 기계적 성질에 미치는 Quenching온도 및 냉각속도의 영향
한국재료학회지
2012 .01
-
고온 초전도체 팬케이크 코일의 퀜치 해석
한국초전도·저온공학회논문지
2009 .01
-
STD61 공구강의 내충격 및 내열피로 특성에 미치는 가스 퀜칭 압력의 영향
열처리공학회지
2016 .01
-
Quench Characteristics of YBCO Film for Current Limiting Using Magnetic Field
Progress in superconductivity
2002 .01
-
마이크로 연소기에서 발생하는 열 소염과 화학 소염 현상 (Ⅱ) : SiOx(x≤2)플레이트의 물리, 화학적 성질이 소염에 미치는 영향
대한기계학회 논문집 B권
2006 .05
-
MRI용 초전도 마그네트의 ?치보호회로에 대한 연구
한국초전도저온공학회 학술대회
2001 .01
-
Quench에 의해 유도되는 액체 N₂의 절연파괴 특성
전기학회논문지 C
1999 .01
-
보론강 판재 핫스탬핑시 직수분사냉각 공정의 적용성
한국재료학회지
2019 .01
-
프레스 퀜칭 공정에 의한 자동차 Flexible Plate의 형상 제어 연구
열처리공학회지
2008 .01
-
핫프레스포밍 공정의 냉각치구 설계에 관한 연구
한국소성가공학회 학술대회 논문집
2009 .05
-
Superconducting Transitions of $(Pb,V)Sr_2(Ca,Er)Cu_2O_z$ Quenched from High Temperatures
Progress in superconductivity
1999 .01
-
고효율 급속냉각을 적용한 열간 자유 단조품의 특성 연구
한국소성가공학회 학술대회 논문집
2017 .10
-
펄스전류 운전에 따른 KSTAR PF 초전도자석의 퀜치 분석 및 퀜치 검출 시스템 운전 특성
한국초전도·저온공학회논문지
2009 .01
-
半絶緣 갈륨비소의 赤外線 映像에 의한 웨이퍼成長條件 및 溫度從屬 퀀칭율 證明
전자공학회논문지-SD
2003 .07
이 논문의 저자 정보
최근 본 자료
댓글(0)
0
UCI(KEPA) : I410-ECN-0101-2009-556-014071716