본 연구의 목적은 기계체조 철봉종목 내리기 동작 중 가장 많이 시도되는 고난도 기술인 기계체조 몸 펴 뒤 공중 2회전 돌면서 720°비틀기 기술에 대한 운동학적 분석을 통해 착시 동작 시 상해요인을 분석하는데 있다. 본 연구대상은 엘리트 남자 대학 체조선수 6명으로 몸 펴 뒤 공중 2회전 돌면서 720°비틀기 기술의 착지구간을 분석하기 위해 4대의 고속카메라를 이용하여 촬영하였다. 대상자의 3차원 좌표를 수집하기 위해 신체를 19개의 인체관절점을 연결된 강체구조로 정의하고, 각 분절의 질량중심과 전신의 질량중심의 위치를 구하기 위하여 신체분절지수는 Plagenhoef, Evans와 Abdelnour(1983)의 자료를 사용하였으며, 촬영된 자료를 통해 신체중심 변위와 속도, 하지관절의 각도와 각속도를 Kwon3D XP 프로그램을 이용하여 산출하였다. 또한, 착지 동작 시 운동학적 요인의 평균과 표준편차를 산출을 위해 SPSS 21.0 프로그램을 사용하여, 다음과 같은 결과를 얻었다. 첫째, 몸 펴 뒤 공중 2회전 돌면서 720°비틀기 기술의 착지구간 소요시간은 0.10±0.06s로 나타났다. 둘째, 신체중심 변위는 수직 하방향의 이동범위가 0.17±0.03m로 나타났다. 셋째, 신체중심 속도는 수직 하방향에서 가장 빠르게 나타났다. 넷째, 하지관절의 가동범위는 무릎관절의 가동범위가 가장 큰 것으로 나타났다. 다섯째, 몸통 기울기의 가동범위와 무릎 외반각도의 가동범위는 착지 시 자세제어에 중요한 역할을 하였다. 여섯째, 하지관절의 최고 각속도는 발목관절, 무릎관절, 엉덩 관절, 몸통의 순서로 크게 나타났다. 이상의 결과를 종합한 결론으로, 몸 펴 뒤 공중 2회전 돌면서 720°비틀기 기술의 착지구간에서 소요시간은 충격시간으로써 상해의 위험성을 보였고, 신체중심의 좌·우 변위와 전·후 변위는 상대적으로 작은 이동범위를 보여 안정적인 착지의 자세제어를 보였으며, 신체중심 속도는 수직 하방향에서 상해의 위험성을 보였다. 또한 하지관절의 가동범위는 무릎관절에서 상해의 위험성을 보였고, 몸통 기울기의 가동범위와 무릎 외반각도의 가동범위는 착지시 자세제어에 중요한 역할을 하였으나 상해의 위험성을 내포하고 있었으며, 하지관절의 최고 각속도는 발목과 무릎관절에서 상해의 위험성을 보였다. 따라서 이러한 요인을 중점적으로 신체에 미치는 부하를 최소화할 수 있는 제어 훈련이 필요할 것으로 사료된다.
Purpose: The purpose of this study is to analyze the factors of causing injury through the kinematic analysis of the landing phase on Double salto bwd str. with 2/1 t., the most trying and high level technique of horizontal bar in gymnastics. Methods: The subjects were 6 elite male college gymnasts were recorded their motion using 4 high speed cameras to analyze the landing phase on Double salto bwd str. with 2/1 t. In order to collect the three-dimensional coordinates of the subject, the body was defined as a rigid structure connected to 19 human joint points. To obtain the center of mass of each segment and the center of mass of the whole body, the body segment index was calculated by data of Plagenhoef, Evans & Abdelnour(1983). To calculate the displacement and velocity of COM(center of motion), the angle and angular velocity of lower extremity, captured motion data analyzed by Kwon3D XP program. Also, the mean and standard deviation of the kinematic factors during landing were calculated by the SPSS 21.0. Results: First, the time required for the landing zone of Double salto bwd. str. with 2/1 t. was 0.10±0.06s, second, the displacement of COM was the largest with a vertical ROM(range of motion) of 0.17±0.03m, third, the velocity of COM was the fastest in the vertical direction, fourth, the ROM of the lower extremity showed the greatest ROM of the knee joint, fifth, the ROM of the trunk tilt and the ROM of the knee bowing angle played an important role in the landing attitude control, sixth, the maximum angular velocity of the lower extremity was in the order of ankle joint, knee joint, hip joint, and trunk. Conclusion: in the landing phase of Double salto bwd. str. with 2/1 t, first, the time required is indicating as the time of the impact and showed the risk of injury, second, the left and right side displacement and the front and rear displacement of COM showed a relatively small ROM and showed stable landing attitude control, third, by the results of the velocity of COM, the vertical direction showed the risk of injury, fourth, by the results of the ROM of the knee joint is indicating the risk of knee injury, fifth, by the results of the ROM of the trunk tilt and knee bowing angle is indicating the risk of injury, sixth, by the results of the maximum angular velocity of the lower limbs showed the risk of injury in ankle and knee joints. Therefore, it is considered the control training that minimizes the load on the body is needed to focus on these factors.